Knot in October GAW
-
I think Ray Mears uses this knot--or one very like it--to secure his hammock's ridge line when camping in the Amazon. (I can't be certain, but I think so....)
-
@Nix said:
I've spliced in another BRK Bravo-1, this time a model with the thumb ramp:You're not the only one -
With bends, hitches, and loops out of the way, there is another technique...though usually you'll only use it once :P
You could call this a "multi strand loop" if you want, or just an eye splice....
Not so easy to just untie and demo, so you'll have to be patient for me to get photos of a new one being made - for now, though, the finished product.
The eye splice has a hundred and one uses on its own, but the real beauty of the technique is in prolonging the life of three strand rope - If you've got significantly damaged portions, you can remove them and splice the healthy lengths back together, if you're rubbish at whipping, or you want a reliable solution to fraying ends, you can back splice.
You can use two splices to put a loop midway on a line, known as a...ahem cut splice....
-
My next entry is the reversed half hitches.
Find it handy for fastening the dogs lead when I have to
You start by going around whatever you are fastening to.
Then over, under and up through the loop.
Then you go over, under and up through the second loop and thighten and dress the knot and it's done, nice and easy and it's easy to undo again


Sent fra min FRD-L09 via Tapatalk
-
@Sea Monster said:
You're not the only one -With bends, hitches, and loops out of the way, there is another technique...though usually you'll only use it once :P
You could call this a "multi strand loop" if you want, or just an eye splice....
Not so easy to just untie and demo, so you'll have to be patient for me to get photos of a new one being made - for now, though, the finished product.
The eye splice has a hundred and one uses on its own, but the real beauty of the technique is in prolonging the life of three strand rope - If you've got significantly damaged portions, you can remove them and splice the healthy lengths back together, if you're rubbish at whipping, or you want a reliable solution to fraying ends, you can back splice.
You can use two splices to put a loop midway on a line, known as a...ahem cut splice....
I do know the correct term.... ;)
I had a sea-farring Brother-in-law who taught me to splice three-strand. It's a real skill....one that I never mastered...but can still manage.
I spliced an eye in this rope to use in one of the truck's tie-down rings. It just seemed easier to slip the loop through and then feed the rope back through the loop than tie a bulky knot there. And I believe a good splice (not pictured above) is stronger than any knot.
Cool skill to have; I should practice more.

-
I do know the correct term.... ;)
I had a sea-farring Brother-in-law who taught me to splice three-strand. It's a real skill....one that I never mastered...but can still manage.
I spliced an eye in this rope to use in one of the truck's tie-down rings. It just seemed easier to slip the loop through and then feed the rope back through the loop than tie a bulky knot there. And I believe a good splice (not pictured above) is stronger than any knot.
Cool skill to have; I should practice more.

Aye, I keep a few lengths of cord with eyesplices laying around for just this purpose - the eye makes an easy cow hitch through a shackle or tie rail.
If you really want, you can have both ends with eyes - then the other end can be used for a variation on the truckers hitch, fed through another "link" to extend it, (giving the appearance of a reef knot...) or whatever else you may need.
There's a few other variations you can do when tying depending on how it is going to be used - you can tie a half hitch before the rope - this can assist with very narrow and slippery material (say for a knife lanyard) - more of a detriment in a lot of other applications. You can taper the splice by cutting the strands to different lengths, which will give a smoother finish.
Some people like to put whipping over their splices. It's not really required, but if you are using it in an anchor chain or something, it may be worthwhile as all that wet/dry/going through the bowroller can be hard, and you want confidence that your anchoring system isn't going to fail at any point :P
To do good splices takes a bit of preparation and some basic tools.
Mine are normally done by hand while watching the telly on the couch, so they're all over the shop in terms of consistency and quality, but since I don't use three strand for any rigging applications anyway, they're good enough for my purposes.
For people who are into this sort of thing - a 6 foot bit of rope with a couple of eyesplices was standard equipment for british commandos - it was considered just that handy.
-
Nice one, RF!
Another straightforward knot that gets used a good bit. I think the pair of half-hitches was the only knot my father knew. He could be taught other knots, but he would forget them in short order, so everything he tied down got finished with a pair of half hitches.
Take the working line around a post or ring a second time, and you end up with the classic "Round turn and two hitches." This seems to get used in nautical circles (no pun intended). The extra turn gives the knot a bit of extra holding power, I think. Might be a good idea if your dogs are large and very active.


You guys can probably tell by now that I like a quick release knot and add a slippery bight to the end of many knots. I've found this to be useful when tying down gear or tying up a dog:

-
@Sea Monster said:
Some people like to put whipping over their splices. It's not really required, but if you are using it in an anchor chain or something, it may be worthwhile as all that wet/dry/going through the bowroller can be hard, and you want confidence that your anchoring system isn't going to fail at any point :PMy whipping is worse than my splicing....
Ashley has some good pointers on whipping, though... 
-
http://www.1stairborne.com/webgear.html
Oh, I enjoyed that.

A short Wiki entry on the toggle rope: https://en.wikipedia.org/wiki/Toggle_rope
-
Another straightforward knot that gets used a good bit. I think the pair of half-hitches was the only knot my father knew. He could be taught other knots, but he would forget them in short order, so everything he tied down got finished with a pair of half hitches.
Take the working line around a post or ring a second time, and you end up with the classic "Round turn and two hitches." This seems to get used in nautical circles (no pun intended). The extra turn gives the knot a bit of extra holding power, I think. Might be a good idea if your dogs are large and very active.


You guys can probably tell by now that I like a quick release knot and add a slippery bight to the end of many knots. I've found this to be useful when tying down gear or tying up a dog:

My dad is the same

The half hitches are so simple that I believe everyone knows how to tie it
I trust the half hitches with the one loop around whatever I'm tying my dog to, it has hold up so far, he is about 75-80 lbs and has a tendency to go crazy at other male dogs
Sent fra min FRD-L09 via Tapatalk
-
My 4th entry will be the bowline on a bight knot. Or how we call it here, double bowline. There are many applications of it, some use it to tie in, some to attach the rope to anchor points when decending a rope, some for a Y-hang when the load needs to be evenly devided between two anchor points. It is very easy to tie, and most importantly, untie after being subjected to heavy loads, and I'd say the untie part is the only benefit it has to the double figure 8 knot.
To tie it, make an overhand knot. Flip it over and grab the bottom two wraps and pull them through the loop of the overhand and tighten. Done. But be careful, if you grab the wrong wraps, the top ones, not the bottom ones, you will tie a similar knot, but not a safe one. It's easy to se if it is a good one by applying force to it, if it just tightens the knot and the loops remain, it's good. If the knot slides and the loops get smaller, try again ;)
And most importantly, always clip in through both loops, as if only one loop is loaded the knot might slip, and we don't want that.



-

This is such a fun way to tie a Bowline. It is obviously quite secure. As well...it can be tied in a line where the ends are not free.
A great addition to the growing list!

-
Nice knots!
Anxious to spend some funny hours with my son tying knots in the weekend.
[emoji3]
Enviado de meu moto g(6) usando o Tapatalk
-
That's great to hear. Let us know which of the new knots he likes!

-
[emoji3]
I'll tell!Enviado de meu moto g(6) usando o Tapatalk
-
My spoiler knot: the Jug Knot or Bottle Knot.
This is a fun knot to tie, but can be a bit tricky. It is a knot that gets made by weaving and folding a couple of bights. So that's fun. It is useful for putting a sling on a bottle to sink in a river to chill....so I've heard....
But it is also a great little knot to make a carrying handle for a water bottle--an easy way to tie and extra bottle to a pack, bag, or belt.This will be very picture intensive because I fear that words will fail me. Bear with me: it looks tricky but is actually quick and easy once you get the idea.
To start, form two bights, both crossing under a center point:

I now shift the right hand bight slightly over the left hand bight:


Now, the center section get folded into a bight and pulled under the left hand tail:


Above the bight, there is an oval opening formed by the crossing of the two initial bights. Our new bight gets woven over the near side, and under the far side of this oval.


Our bight now get pulled up and out of the knot to form part of the future handle:


We're getting close!
We now have a loop in the back of the knot, this gets folded down, behind the knot:


In the front of the knot, there is another loop. This gets folded down in the front:


The knot is now done! It just needs to be dressed and snugged down on a bottle:


-
I know this seems complicated, but it makes a wonderful knot that is self-tightening under a load and can be very practical.
The weaving creates something like a Turk's head that makes the knot nice and secure....a bit like the Constrictor.


Give it a try!

-
Looks cool and is probably fun to tie, I'll give it a try, but I'll still most likely stick to my strangler knot for bottles and such. The beast you know, ...
And it uses less cordage, which is always a bonus in my book.

-
True.....
But this is almost a double strangler! :ahhh
-
My fourth entry is the Arbor Knot/Canadian jam knot.
https://en.wikipedia.org/wiki/Arbor_knot
This is the easiest noose you can tie. It is a running knot with a stopper knot. Shawn Kelly (Corporal's Corner) uses it a lot, and it is extremely easy to do. A couple of knots, and you're done.How to tie it:
- Go around the things you want tied.
- Tie an overhand knot around the line (aka running knot).
- Tie an overhand knot with the tail, for the stopper knot.
- You can move the two knots closer to minimize used length.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
