Livarno, Romisen, C8, Small Sun cheap HID torches
-
Utorch V8 XPL Available with stepless dimming or separate modes (cheaper)
Compared with the BLF A6
Impressive matt finish, nice squared threads - It can easily carry a Fenix, Olight etc. sticker.
Appears only slightly dimmer than the A6 Avery good buy, at half the money, under 8 Euro.
PWM is bad, the A6 one is way better.
OP reflector, slightly smaller pits than the A6.Utorch on the left in the beam photograph




-
I got a new Nitecore TIP SE to replace an older (2015) TIP
The original one still works fine but one rubber button was torn, so I put a rubber tyre patch on top of it. Still, since it is no longer weatherproof I decided to get a new one to replace it.
Issues with the old one? The torn button and the very poor resistance to friction of the anodisation. It used to be blue but the colour has gone. In comparison, an old, used LM squirt, carried on the same key-chain for even longer still looks pretty good. I have included a photograph with a Tank light, carried for way more years, for comparison.
Basically, the SE has twice as many LEDs and of a different brandthan the old one, twice as many Lumens on Turbo and a USB C charging port instead of the USB Micro. The low, medium, high modes are about the same. So is the size and overall functions.
If you do not need the higher Turbo mofde then there is no reason to upgrade.
The original one cost me 18 USD and the new one 29, shipped to me.
The new one has a slightly wider beam, though they are both fine.
-
I think a problem with the coating may be that it's a flatter profile light, so more of the surface is exposed to friction at any given time. The tank light example you gave along with it is entirely bare of ano at the points of contact, whereas the TIP still has a bit of a 'hue' to it. Looking forward to seeing how it holds up overall, it's an interesting light that's for sure!
-
The LM squirt was on the same keychain and that also has flat sides. It has minimal damage to its coating.
-
@dks said:
The LM squirt was on the same keychain and that also has flat sides. It has minimal damage to its coating.That probably says something about the Leatherman ano rather than the Nitecore's...
I've never known ano to hold up to prolonged keychain use (over years) without substantial loss (usually 100%) at the points of contact.
It'd be a better metric if you could gauge how quickly it lost the ano, rather than the end state after years of key carry.
-
The anodized finish on the TIP always struck me as being very thin as well. Good light though and I still like my CRI. As you say; I'm not certain I'm going to rush out and replace it with the new version just yet. Cheers for the pics and thoughts mate.

-
Jetbeam Mini One SE
This is another small keychain light, available with a metal or plastic opaque body and metal head (SS). It is also available from Nitecore, with lower power output - Nitecore Tiki. (Nitecore and Jetbeam are related, from what I know, part of Sysmax)
Having an internal battery and an on/off button helps it to be quite small, comparable to an AA battery.
Specifications can be found here : http://www.jetbeamlight.com/products_show318.html
The turbo output is 500LM (30s) and it has regular modes from 200 to 1LM (could have been lower). Nice white beam.
I have included some comparison photographs with the Tank007E09. The beam comparisons are done with both on High, Tank at 120 and Mini at 200LM. The Mini has a hotter central spot and more spread.
The light brings many functions of cheaper. fun, lights to a product made by a real company.
It has, in addition to the standard beam, 4 extra lights on its side.
3 are powerful (150LM) coloured LEDs (R, G, B) that can flash in sequence. This function is useful when walking (the reason I got this light) or for parties....
You can also have just the red LED flashing, like a beacon, just the red or blue on etc.1 is a UV light, reasonably bright that can be used for various tasks, like checking the cleanliness of toilets, checking money and so on.
You access the main modes by number of clicks and then change through the variants with longer clicks. Easy and simple.
Why did I get the plastic bodied one instead of the metal bodied one?
The plastic one luminesces in the dark (like watch dials). The metal one does not.
When you use the coloured LEDs in the plastic one, you get light form all around the body of the light, making you more visible. With the metal one, if you accidentally cover the LEDs with your finger or body then you will not get any light coming out.
The plastic one is cheaper - about 18USD should get you one to Europe, whereas the metal one is a few USDs more, usually
However, the metal one looks fancier/classier and should be tougher.
-
UV light
-
You miss me here? ;)
Some interesting lights, I like that BLF one with the 4 parallel cell setup, but I'd prefer it to be a flood light for photographing large dark spaces.
And the last keychain light is cute. It wouldn't push out my old trusty ITP A3 SS off of my keychain but it would be a nice toy to play with ;)
Also nice to see you still loving the Tank, I'm guessing it's your favourite keychain light still, right?
-
You and Gareth keep this thread alive.
The tanks never die, I just replace them occasionally with something fancier on keychains.
I still have the original 3 or 4 that I bought and they work as new. That one has been continuously on the keychain for several years.
There are a few new BLF lights available too, but I am generally happy with what I currently have - though I did go to BLF a few days ago and ended up ordering another light.....
The only light that needed replacing in the past few years was the nitecore tip.
The runtime, beam quality and brightness you can get from the newer lights is impressive, especially compared to what you were getting about 10 years ago
-
I have one of those Tanks in the collection but rarely carry it, still works great though and I understand why you like it so much.
I know the BLF specials can be very nice, I have a BLF Mini CR123 and the Starry Light SA-22 BLF Edition I think you also have, with the 4xAA setup and they are great bang for the buck. But I don't go to BLF anymore that often so am not familiar with what the newest offering is.
I found my sweet spot both in multitools, SAKs and flashlights some time ago and am not searching for the newest best thing anymore as I used to. But it's nice to read your views on them, you know I enjoy these posts a lot.
-
I go to BLF once a year... usually end up buying something.
The starry light works well too, apart from some discolouration/deposits in the lens, which can not be easily removed to be cleaned.
I though it had some problems a few weeks ago, but it just needed a new set of batteries as the old ones, eneloops were not charging properly.
-
Glad to be of service. :D
The new Jetbeam looks like update of the Tiki for sure. Different charging port, LEDs and different UI. I like the idea of it being glow in the dark too. I've had my Tiki on my keys nearly every day of the last 10 months and honestly I can't see a single blemish on the plastic.
-
The actual high on the TIKI is higher, 300LM instead of 200, though the Turbo on the Mini is 500.
The Tiki also has a bigger battery, and noticeably better, on paper, runtimes. -
I was thinking that the turbo was rated at more than 200 when I bought mine. :)
Looking at the two I suspect that I'd still buy the Tiki over the One SE. However that's a matter of preference and each to their own. The Rovyvon range is worth a look too but, again, the specific features of the Tiki seemed to suit me best.
-
Turbo on MINI 500LM (as long as you keep the button pressed), regular high 200
on the Tiki, no turbo but regular high is 300LM -
After wandering into BLF I ended up ordering a couple more lights. This is one.
Sofirn D35S.
Sofirn seems to be fashionable these days and gets decent reviews (This happens with many companies that appear for a while, make good products and sometimes just disappear - hopefully they will stay)
This was just over 15 USD delivered to me in 2 weeks from China. I ordered from their website, which seems to have the best prices.
Came in a branded box with an A4 English manual.
No branding on the light, which seems to be sold under other names too.Specifications:
Emitter: SST40
Material: Aircraft-grade 6063 Aluminium Alloy
Nominal voltage: 3.7V
Power Source: 1x 18650 rechargeable battery
Dimension: 86mm (length) × 25mm (head diameter)
Weight: 2.9 ounces (Excluding battery)
Five Light Modes:
Low: 70LM; Medium 1: 120LM; Medium 2: 300LM; High: 600LM; Turbo: 1200LM
Also, Strobe and Beacon. Simple interface with one button.I ordered the version with the battery, branded Sofirn, though I do not know who makes it. The version with the battery was cheaper than the one without, at the time.
Comes with a simple but effective headband.The light can be adjusted for angle whilst on your head.
Feels reasonably light. I used it for half an hour working on a car and it felt fine.
It comes with USB charging. The charger contained in the light charged the battery to around 4.10V, using a 0.5V USB suply. I was able to add another 200mAh using an external charger. The charging point is nicely hidden by a cap, which you unscrew to use it – see photographs.
If you do not care about the extra mAh the included charger is fine as it slightly undercharges, which does not do the battery any damage.
The battery can be removed easily for charging, though the screw cap for the battery feels really thin, reminding me of screw caps on cigar tubes. I assume this was done to save weight, but it does not feel very strong.For some reason they went with two LEDs, though they could have used one as the total output is not that high.
So, the LEDs should be pretty unstressed and last long.The beam is wide, as the orange peel reflectors are quite small. Slightly green, but not noticeable in actual use.
In the photographs you see a comparison with a BLF nide that produces about the same maximum brightness.They could have saved more weight by having one LED and no USB charging, I assume.
Anodisation is good.
The Low is not that low at 70Lm – this is what bright incandescent lights used to make remember….
Appears very “industrial”. No effort was made to make it look nice.Good light for well under 20USD, from a maker with good reputation. Good shipping too – these days it takes longer to get something from within Europe than from China.
-
.
-
This looked cool and interesting until I saw the reflectors. Why two orange peel ones?
Seems like a waisted opportunity to make it a much more versatile light. One orange peel for flood and one smooth for throw. But that would probably require an additional switch and be a tad more expensive.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
