Skip to content
  • Categories
  • Recent
  • Popular
  • World
Skins
  • Light
  • Dark

Collapse

NodeBB

byrd wings slippit

Scheduled Pinned Locked Moved Reviews
17 Posts 1 Posters 4.3k Views
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • H
    H
    heavy handed
    wrote on last edited by
    #1

    this knife comes packaged in a green box with a blister pack with byrds evolution continues diagrams.

    it is 3 3/4 inches long, and has the dual blade format 1x PE and 1xSE. both blades are 8cr13mov

    this knife looks odd and looks very uncomfy to hold , the choil and jimping is good on the underside of the blade, the index finger sits quite nice in the gap and the thumb sits nice on the upper thumb ramp(no jimping). the middle finger then rests on the other closed blade this has nice recurve on feels like you are holding the handle of the knife.

    but the ring and pinky finger feel a little akward resting above the "comet" hole in the blade, they feel like they are too far away from the handle and im not getting the best grip possible. while doing some test cuts in rope and paper etc, i have found myself gripping the knife with my thumb, index and middle finger only. i think this knife maybe a little to uncomfortable to hold for an extensive amount of time. but that aside having the option of a SE and PE blade appeals to me so because of the dual blade i can over look the ergonomics of the closed blade.

    the knife has a 4way carry option and the clip is very secure sitting in the stainless steel end of the handle with 3 torx screws. the middle part of the handle is black g10.

    the fit and finish is good, though there are a few minor points, the back spacer on the SE blade has an ever so slightly bigger gap between the handle than the PE spacer, but to be honest it does not affect the opening or closing of the blade and i only noticed it as i was looking for any defects, and also the SE edge blade has the tinyest of tiny bit of blade roll right at the tip. you cant really see it but its enough for my thumb nail to catch the rolled over bit ,but again i wouldnt of noticed it if i wasnt loking for it. this has not put me off the knife in any way as this will be my edc knife for work leaving my bob t beign my "dress" knife.

    over all this feels very solid due to its stainless steel construction(including liners), its not the lightest edc knife but its not the heaviest, also i find the "comet holes" eaiser to OHO than the round spyde hole. i hope to give this a good run at work so i should be able to do a long term report on the knife. the only down side is that i cannot get a full comfy finger grip when using the blade, but as i said before i can over look that due to its usefulness of the two blades. would i recommend this knife, yeah i would its not too expensive, its uk legal and gives you twice the fire power. so its a thumbs up from me. :tu: id give it an 7/10 for 1st impressions.

    Heavy handed

    1 Reply Last reply
    0
    • Mike, Lord of the Spammers!M
      Mike, Lord of the Spammers!M
      Mike, Lord of the Spammers!
      wrote on last edited by
      #2

      I'm so tempted to get one after Xmas :tu:

      1 Reply Last reply
      0
      • H
        H
        heavy handed
        wrote on last edited by
        #3

        ill do a mini review before xmas to let you know how its holding up. 😉

        1 Reply Last reply
        0
        • Mike, Lord of the Spammers!M
          Mike, Lord of the Spammers!M
          Mike, Lord of the Spammers!
          wrote on last edited by
          #4

          @heavy handed said:
          ill do a mini review before xmas to let you know how its holding up. 😉

          Thanks mate 🙂

          Nothing beats experience in a review :tu:

          1 Reply Last reply
          0
          • BennerB
            BennerB
            Benner
            wrote on last edited by
            #5

            Nice little write up mate. :tu:

            Just can't get excited about this one though. 😕

            1 Reply Last reply
            0
            • H
              H
              heavy handed
              wrote on last edited by
              #6

              a few pics.

              103.JPG

              102.JPG

              1 Reply Last reply
              0
              • Z
                Z
                zepla
                wrote on last edited by
                #7

                I like the two blade concept. As I understand it it does not have locking blades?

                BTW good review, thanks! :tu:

                1 Reply Last reply
                0
                • BennerB
                  BennerB
                  Benner
                  wrote on last edited by
                  #8

                  @zepla said:
                  I like the two blade concept. As I understand it it does not have locking blades?

                  BTW good review, thanks! :tu:

                  Nope, hence the name "slippit".

                  Great for us UK guys. :tu:

                  1 Reply Last reply
                  0
                  • GarethG
                    GarethG
                    Gareth
                    Admin Team
                    wrote on last edited by
                    #9

                    I'd be much more tempted if it only had one blade, having the other OH hole sitting under your ring and little finger never looked comfy to me and HH has confirmed it. Also it's a righty only knife as I wouldn't be able to get my (leftie) thumb at the hole what with the other blade sitting in the way.

                    Please Sal, make a single blade version. 😕

                    1 Reply Last reply
                    0
                    • Z
                      Z
                      zepla
                      wrote on last edited by
                      #10

                      @Benner said:

                      @zepla said:

                      I like the two blade concept. As I understand it it does not have locking blades?

                      BTW good review, thanks! :tu:

                      Nope, hence the name "slippit".

                      Great for us UK guys. :tu:

                      Ah ha, I see. Not my brightest moment I guess ::)

                      1 Reply Last reply
                      0
                      • BennerB
                        BennerB
                        Benner
                        wrote on last edited by
                        #11

                        I have those moments, pretty much all day every day. 😄

                        1 Reply Last reply
                        0
                        • H
                          H
                          heavy handed
                          wrote on last edited by
                          #12

                          byrd wings slippit update.

                          ive been carrying this knife every day at work now for a month.
                          in the initial review my two main gripes were of the ergo of the closed blade and the bent tip of the blade.

                          i noticed that when i opened either of the blades one handed my index finger rested on the other blade, causing me to push the closed blade tip under the choil of the blade i was opening, where you could hear a slight grinding noise, this i found out was the reason for the rolled tip, i now open this knife 2 handed and i no longer get the edge roll.

                          the design of the knife im also used to now. 90% of my cutting tasks are for no more than a couple of mins at a time, eg open boxes, cut rope, pipe lagging etc. i found that the knife feels quite natural in the hand.

                          this knife has been used daily, it gets coverd in dirt ,oils and grease, and loads of pocket fluff. and it cleans up well and easily. i have had no problems with any rust issues.
                          i would feel lost if i didnt have this 2 bladed knife on me, i use the SE for aggressive cutting eg cardboard and rope and cable ties and leave the PE blade for slicing, the PE blade still slices through paper. neither blade has needed to be resharpened as they are holding a good working edge.

                          overall im very pleased with this knife, may be for the 1st week i was trying different grips when cutting but now it feels like any other knife.

                          would i recommend this knife , yeah. it may not be the best looking or the most comfortable for extended use but it is one hell of a work horse.
                          (mike, i think this one should deffo go on the xmas want list),

                          heavy handed

                          1 Reply Last reply
                          0
                          • Mike, Lord of the Spammers!M
                            Mike, Lord of the Spammers!M
                            Mike, Lord of the Spammers!
                            wrote on last edited by
                            #13

                            Thanks for the update mate :tu:

                            1 Reply Last reply
                            0
                            • R
                              R
                              ringzero
                              wrote on last edited by
                              #14

                              @heavy handed said:
                              i noticed that when i opened either of the blades one handed my index finger rested on the other blade, causing me to push the closed blade tip under the choil of the blade i was opening, where you could hear a slight grinding noise, this i found out was the reason for the rolled tip, i now open this knife 2 handed and i no longer get the edge roll.

                              This looks to be a fairly serious defect in the knife's basic design. Guess it could be a manufacturing issue, instead.

                              Wonder if Spyderco is even aware of this issue.

                              There was some discussion of rolled tips over on British Blades, but it was attributed to bad steel which seemed unlikely to me.

                              .

                              1 Reply Last reply
                              0
                              • H
                                H
                                heavy handed
                                wrote on last edited by
                                #15

                                ill have to check that thread out, thanks mate :tu:
                                as ringzero says i think it could be a slight design glitch and not a steel problem as the rest of edge on both blades is fine and they have been used daily.

                                1 Reply Last reply
                                0
                                • S
                                  S
                                  shecky
                                  wrote on last edited by
                                  #16

                                  I've had one since they came out last Spring. I've been pretty much smitten since.

                                  Fit and finish on mine is flawless. Heavy Handed's grinding noise may be due to... heavy handedness. I can replicate the noise, if my fingers rest on the closed blade when opening up the other, by pushing the closed blade laterally so that the "nose" of the closed blade rubs against the jimping on the choil of the opening blade. The grinding noise is the spine rubbing against the jimping. However, it seems I have to be pressing pretty hard on the closed blade to get it to rub all the way down to the edge. Mind you, this happens when I tried to make it happen. Normally, my fingers don't put that much pressure on the closed blade.

                                  One thing that does occur to me is that despite the two blades and four different pocket clip positions, it's not a left hand friendly design. No matter how the clip is positioned, or even if it's removed, the blades are in the wrong position to be opened left handed via thumbholes.

                                  I haven't taken the knife apart, but it seems it may be possible to mod it into an even thinner single blade. As is, it's about as thick as a FRN Native. It seems to have all screw construction. The pivots and scales are held by Torx screws. I presume there's a hidden pin under the scales holding the backsprings. It may also be possible to swap the blade positions to make it southpaw friendly.

                                  1 Reply Last reply
                                  0
                                  • H
                                    H
                                    heavy handed
                                    wrote on last edited by
                                    #17

                                    @shecky said:
                                    . Heavy Handed's grinding noise may be due to... heavy handedness.

                                    lol. 😄

                                    1 Reply Last reply
                                    0

                                    Hello! It looks like you're interested in this conversation, but you don't have an account yet.

                                    Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.

                                    With your input, this post could be even better 💗

                                    Register Login

                                    • Login

                                    • Don't have an account? Register

                                    • First post
                                      Last post
                                    0
                                    • Categories
                                    • Recent
                                    • Popular
                                    • World