Show us your fixed blades
-
Corrugated, check your local Army Barracks type stores.. My local AB has tons!
-
@Corrugated said:
Where do you get your "strike anywhere" matches Spork?I usually get mine at OSH (Orchard Supply Hardware)...I think it's a chain is confined to California though.

-
-
Now that is a VERY fine blade sir

I'm bloody envious mate

-
That is gorgeous

-
That is very nice mate

-

hand forged 120mm x 5mm bushcraft knife,has two sharpening angles,for chopping and "whittling",and the end of handle is hardened to act as firesteel.
and good old m95 with fallkniven s1.
these i haul with me in school,not all,but one at the time.nothing special or fany but these have been proved to be sturdy,take some batoning easily and easy to sharpen...except for that oddball convex-S1.but the convx will be history and it will have scandi grind.
-
I made the sheath for this Victorinox Rabbit knife today :P


-
What do you use it for mate ???
I'm assuming only for really light duties :)
-
Not quite sure yet...it is the only knife in the Fibrox line that looks like it might work as a field knife. The reason it is called a Rabbit knife is that it is intended for boning rabbit...and I assume other game animals.
The blade itself is a stiff wide boning type, at the spine it is about the same thickness as a Mora Clipper.
I sharpened it as I would a SAK...widened the secondary bevel a bit and rounded the shoulder on sandpaper to a slight convex. It is stupidly sharp and makes shavings easily on the poplar and cedar I tried it on.
While I would not carry it as a primary, it would work well as a Bird-and-Trout...as well as a camp kitchen knife.
It only cost $10 and I thought I would give it a go and see what it is capable of.
-
Here's my old LL Beans Trout knife...basically a flexible narrow boner...carbon steel and also capable of getting stupidly sharp. Cleaned a lot of trout and squirrels with this one in my teens...back when I only had a couple of knives :P

-
Lovely patina on the trout knife mate

-
I think that patina is older than Benner...I've had that knife since about 1976 :D
-
Couple of new ones today...
Boker Dozier Anchorage and an Ontario Ranger Shiv.

-
That Shiv is pukka

-
Right now I'm restraining myself from re-profiling the edge and stripping off the paint. I'm just going to polish up the factory edge a bit and see how it works in it's original configuration before I do any alterations.
-
It's a Ninja-Bushcraft knife :P
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

