Knot in October GAW
-
Fantastic explanation and examples ....... Thanks SOS :D

Much easier to see with the single constrictor

-
-
OK - I really should post earlier in the week..... Or at least post immediately after I took my photos ..... because.......
I took photos of my Figure of Eight yesterday when I took my Yosemite Bowline piccies - Ready to post today .....
But of course enki
knicked my knot ..... Knot funny >:(Anyway seeing as I had the pics already I will post them and say a few words about the use of the knot.
It's slightly different from Enki's Figure 8 - No bight - But essentially still a double threaded Fig 8.So this is how ***nearly all ***UK crag climbers tie into a rope..... See diagram/piccie.
-
You take the rope and tie your first Fig 8 about 1 metre from the end of the rope
-
You then thread the free end through the waist loop and (very importantly) the groin loop of your climbing harness
-
You then feed the free end back around the Fig 8 following the line of the rope all the way - as you see in the diagram/piccie
-
And probably ...... as always ,,,,,,, finish off with a stopper knot - Which I do not show

Perfect!!
As mentioned earlier this knot takes longer to tie than a Bowline, is way harder to undo under strain ie if you fell on it
But is easier to tie, less chance of a mistake and much easier for your partner to check .......as you can see !!I will say a few more words about the Fig 8 when I make my post for this week!! :o
-
-
I was vaguely worried that the humble Clove Hitch would be overlooked. Yet, it is one of the most fantastic knots ever conceived. From docking freights to securing a truck's load the Clove Hitch is always ready, willing and able!
There is a magical quality to the Clove Hitch: it almost seems too simple to work. Yet...it will hold tons.
Here is a shot from a recent camping trip, a slippery Clove Hitch securing a guy line perfectly:

Looking at the photo, it seems tied a bit sloppily. And it is loaded slightly off to the side. No matter! The Clove Hitch prevails!
I'd put the Clove Hitch up in the "Top Five Essential Knots" to know. No kidding--fantastic knot.

That was going to be my 2nd entry...

-
- The rabbit's hole :)
- The rabbit approaches the hole. :D
- Misses it but sees another one. :-\
- Misses it again. >:(
- One hole capsizes as the fabric of reality folds over itself.

- One hole swallows the other one. :ahhh

-
@Huntsman said:
OK - I really should post earlier in the week..... Or at least post immediately after I took my photos ..... because.......I took photos of my Figure of Eight yesterday when I took my Yosemite Bowline piccies - Ready to post today .....
But of course enki
knicked my knot ..... Knot funny >:(Anyway seeing as I had the pics already I will post them and say a few words about the use of the knot.
It's slightly different from Enki's Figure 8 - No bight - But essentially still a double threaded Fig 8.So this is how ***nearly all ***UK crag climbers tie into a rope..... See diagram/piccie.
- You take the rope and tie your first Fig 8 about 1 metre from the end of the rope
- You then thread the free end through the waist loop and (very importantly) the groin loop of your climbing harness
- You then feed the free end back around the Fig 8 following the line of the rope all the way - as you see in the diagram/piccie
- And probably ...... as always ,,,,,,, finish off with a stopper knot - Which I do not show

Perfect!!
As mentioned earlier this knot takes longer to tie than a Bowline, is way harder to undo under strain ie if you fell on it
But is easier to tie, less chance of a mistake and much easier for your partner to check .......as you can see !!I will say a few more words about the Fig 8 when I make my post for this week!! :o

(I believe the Figure 8 is also stronger than a Bowline. I.e. the knot doesn't weaken the rope as much as a Bowline.)
-
Gordian knot
How to tie it: unknown (at least to me)
How to untie: use a sword (or scissors)
-
You're a braver man than I am if you were willing to try that one.
-
Just want to hop in super quick to say how I appreciate this thread, been binge reading it and currently on page 6.
Great GAW and awesome read!

-
@Sos24 said:
I can see why you would say that, because they are very similar, but there is another key difference.In the clove hitch the two ends are side-by-side, but in the constrictor knots the ends overlap a d apply pressure to each other.
Maybe the best way is visual. Here is a picture of the clove hitch, single constrictor and double constrictor (L->R) before tightening.

You can see with the constrictor knots, each end is overlapped by the other end where it exits/enters the knot. Because of these overlaps a pull on either end tightens the knot but also presses the opposite end down into the object. The pressure on the opposite end means makes it highly unlikely that the knot will loosen, especially if either end is under tension.
I hope this makes sense, because despite understanding it in my head, I’m not sure I explained it well.
Really nice and usefull knot Sos!
-
@enki_ck said:
Here goes my 2nd entry.One would think I entered more often as I seem to have a variation of a knot or tying it on almost every knot shown.
Sorry about that. 
Now, I mentioned the figure 8 knot many times over already here in the thread as it's the most important and reliable knot I know and use. And to my great astonishment no one has yet used it. :o There are many variations and iterations of it, and I could probably post all my five entries with just those, but we'll see what others have on their minds. ;)
This entry is actually two knots, as it combines the figure 8 with another woven in figure 8. As I used a knot for connecting two ropes the first time around, I decided to continue with the tradition. :D
A double fisherman can be used to connect two ropes of same or different diameters safely. The figure 8 can't. It's only appropriate for connecting two ropes of same diameters. So 10mm rope to 10mm rope and so on. If you use different diameter ropes, the thinner one could slip out, and that's BIG safety hazard. Now, why would one use it then? Cause you can if you make a figure 8 on your first rope, connect the two ropes and also add an attachment point to safely pass a knot on the rope.

So here goes...
Take a bite of a rope and wrap it around itself as shown in the pictures, one wrap around makes a figure 6, also a good and simple knot, two wraps make a figure 8, and if you'd continue passed that and add another wrap before you passed the bite through the hole, you'd make a figure 9. but that's for a knoter knot story ;)
Pull it tight and you have yourself a very safe figure 8. The working end of the rope should always be on the top of your knot so you tighten it even more when under load. And it is important to make it look nice, so no overlaps and crossed threads, every overlap you make reduces the load baring capabilities of a knot by about 25%. See how pretty the knot can look like?
Now, to connect the second rope, you loosen the figure 8 a bit, and pass the tail of the second rope through the two strands, follow the two strands all the way till you've repeated all the wraps around the knot. Tighten it and you have yourself a nice and useful knot.

Nice, beautifull and very usefull knot!
-
@Huntsman said:
OK - I really should post earlier in the week..... Or at least post immediately after I took my photos ..... because.......I took photos of my Figure of Eight yesterday when I took my Yosemite Bowline piccies - Ready to post today .....
But of course enki
knicked my knot ..... Knot funny >:(Anyway seeing as I had the pics already I will post them and say a few words about the use of the knot.
It's slightly different from Enki's Figure 8 - No bight - But essentially still a double threaded Fig 8.So this is how ***nearly all ***UK crag climbers tie into a rope..... See diagram/piccie.
- You take the rope and tie your first Fig 8 about 1 metre from the end of the rope
- You then thread the free end through the waist loop and (very importantly) the groin loop of your climbing harness
- You then feed the free end back around the Fig 8 following the line of the rope all the way - as you see in the diagram/piccie
- And probably ...... as always ,,,,,,, finish off with a stopper knot - Which I do not show

Perfect!!
As mentioned earlier this knot takes longer to tie than a Bowline, is way harder to undo under strain ie if you fell on it
But is easier to tie, less chance of a mistake and much easier for your partner to check .......as you can see !!I will say a few more words about the Fig 8 when I make my post for this week!! :o
Very nice!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login





